Ethernet cables made by us are always the best and economical for us compared to pre-made ones. Just think about buying a 100ft custom ethernet […]
VThank you for reading this post, don't forget to subscribe!
How to test for NPN and PNP transistors using a multimeter.
Interpretation of whether a transistor is a PNP or NPN type has kept a lot of people stranded while picking a transistor. Just imagine working […]
Construction of a half-wave rectifier using a diode.
The half-wave rectifier is an electrical circuit that converts an AC voltage to DC voltage. It achieves this function using one diode. Most of our […]
How to install and wire an electronic transformer.
an electronic transformer is almost the same working principle as an HVAC transformer even due there are still some little differences that exist between them. […]
What is a potentiometer.
The potentiometer is an electrical component that is used to control or in adjusting electrical signals. It is a three terminals pots resistor and an […]
How to calculate the value of SMD resistor.
SMD resistance which means surface mounted technology resistors is resistance in microchips that are mounted on a circuit board. Is quite different from the ordinary […]
How to measure current in circuits using a multimeter.
Current according to ohms law is the ratio of voltage to the resistor. This is the flow of election on the circuit, with s.I unit […]
Easy tips to test a capacitor using multimeter.
Have you been in a situation where you were stuck testing a capacitor? If yes, just have in mind that this particular Post, easy tips […]
How to test electronic diode using a multimeter
To test an electronic diode with a multimeter can be a big task if you’re not familiar with electrical components. However, it’s a vital aspect […]
How to measure the value of a resistor using a multimeter.
To Measure, a resistor is an essential step taken by technicians when designing or troubleshooting a faulty device. It does not only allow us to […]